CHICAGO DREIS & KRUMP - "We build 'em like they had to last forever"

CLICK TO GO TO HOMEPAGE

Email chicago @ Dreis-Krump.com or Call 708-258-1200

BENDING ROLL MACHINES
Chicago Dreis & Krump offers initial pinch bending rolls for rolling sheet metal and light plate. Initial Pinch Rolls with electric/hydraulic power are capable of rolling full or partial cylinders from 16 gauge mild steel to 1/2 inch plate. The lower pinch roll with our special hydraulic powered "quick gap set" is a real time saver during set up. The pinch roll is also tiltable for cone rolling. Hydraulic operation of the drop end for ease of material removal is an added convenience.

As with all Chicago bending rolls, the frames are made of heavy welded construction. The rolls are made from forged steel and heat treated to RC 45. Spherical roller bearings on all three rolls minimize friction loss. The rear bending roll is equipped with an LED readout indicting its position for accurate forming. Positioning of the rear bending roll is done hydraulically and allows the operator to tilt it for cone forming. An emergency stop button and keylock on/off power switch are centrally located on the control panel.

	STANDARD EQUIPMENT: * Hardened Rolls * Hydraulic drop end * LED readout for roll position * Cone forming attachment * Remote forward / reverse control * Roller bearings on roll shafts * Hydraulic powered rear roll adjustment * Power tilt of rear bending roll * Power pinch roll adjustment *Safety cut off cable

INITIAL (Single) PINCH TYPE POWERED PLATE ROLLS

Note: The specifications shown on the Dreis & Krump website may change without notice